Description
- Digital Switching Electronics
- Senses short circuits
- Automatic input voltage sensing
"PowerStar" replaces either of the AGIE wire EDM CNC100 original logic power supplies located in the CNC cabinet or the MS cabinet. The two most common original models are the POWER-ONE CP291A or Intel SBC635. These power supplies are responsible for delivering the several regulated logic voltages to the computer and it's associated boards in either the CNC cabinet or the MS cabinet. AGIE's part number for this unit is 190.037 . PowerStar replaces the original "Linear" electronics with modern "Switching" technology and increases efficiency and noise immunity. Input AC voltage (120 or 240vac) is sensed automatically, so no configuration is necessary during installation. The unit even includes an internal variable speed fan which increases speed when conditions require more power supply cooling. This unit is rated at 250W, far exceeding the original 125W for under-stressed operation. Active Power Factor Correction Meeting with EN61000-3-2. High efficiency and reliability. Low noise and ripple. Output over voltage, short circuit, and over current protection. 100% Hi-pot, ATE, and burn-in tested. Temperature Range: Operating 0 C ~ +50 C on full load; storage & shipping -20 C ~ +65 C. Humidity: 95% on operating and 95% on storage. Dielectric Withstand: Primary to frame ground 1800V AC for 1 second. Efficiency: 65% at minimum measured at nominal AC main voltage and frequency with maximum load on all outputs. MTBF: 100,000 hours on maximum load at +25 C degree. Please note: AGIE provided two different connection output connection styles on the CNC100 line, Please specify your requirement. AEL'7500.001 TechStar PowerStar SBC (for MS250 400 700 and /2 Machines). Two connector cables labeled P6 and P8. AEL'7500.002 TechStar PowerStar SBC (for /3 or AC50 Machines). Two loose connector cables labeled P50 and P51 terminated to screw type terminals.