Description
- Package Includes: (2) Pair Rockville RM-PREMIUM-65 WHITE 6.5" 600w Marine Boat Speakers - Crisp Sound!. (1) Rockville RGHR2 Marine Gauge Hole Receiver w Bluetooth USB, Radio + Wired Remote. (1) Rockville DBM45 4-Channel 2000w Peak/500w RMS Marine/Boat Amplifier. (1) Rockville RMWK4 4 AWG Gauge Waterproof Marine Amplifier/Amp Install Wire Kit. (1) Rockville MRCA25 25 Foot Twisted Pair Marine RCA Cable 100% Copper, Split Pin.
- Features of RM-PREMIUM-65 WHITE: Pair Rockville RM-PREMIUM-65 WHITE 6.5" 600w Marine Boat Speakers - Crisp Sound!. Best sounding Rockville marine speakers!. True Coax Design With the Tweeter Completely Separated From the Cone. Larger Cone Surface Area Gives Better Mids and Lows. Less Mass Attached to the Cone Allows for Higher SPL and Sensitivity. True coaxial design allows for superior sound quality, better stereo separation, and clearer mids and highs. Peak power handling: 600 Watt per pair / 300 Watts per speaker. RMS power handling: 150 Watt per pair / 75 Watts per speaker. ABS Water/Weather Resistant Grills. Fully Marinized Against Salt & Fresh Water Conditions.
- Molded ABS basket for amazing sound and protection from the elements while out on the water. Water and weather resistant Poly Injection Cone. 11 Oz Y35 top of the line magnet supports high power handling. Thick Rubber Surround. High quality ferrite magnet. 1 PEI Neodymium Dome Tweeter has Clear highs. Oversized 1 Kapton Voice Coil. Pre-installed Stainless-Steel mounting screws included. Perfect for Marine, Car, ATV and UTV applications. Impedance: 4-Ohm. Frequency Response: 35Hz - 20KHz. Sensitivity: 93dB @ 1w/1m. Total Diameter: 7.17. Cutout Diameter: 5.787. Total Height: 3.82. Mounting Depth: 2.56.
- Features of DBM45: Rockville DBM45 4-Channel 2000w Peak/500w Dyno-Certified RMS Marine/Boat Amplifier. Dyno Certified RMS Power Ratings: (Certified Dyno Test / Less than 1 % THD) (Use these ratings when comparing with top brands such as Kicker, Rockford Fosgate, etc). 2 Ohm: 125 Watts x 4 Channel. 4 Ohm: 85 Watts x 4 Channel. 4 Ohm Bridged: 250 Watts x 2 Channel. Peak: (Use these ratings when comparing with the top budget brands such as Boss, Power Acoustik, etc). 2 Ohm: 500 Watts x 4 Channel. 4 Ohm: 340 Watts x 4 Channel. 4 Ohm Bridged: 1000 Watts x 2 Channel. Painted Conformal Coating PCB Board (Uses 2577 Waterproof Glue). Waterproof silicone covers for end panels.
- Rustproof Aluminum heat sink with white painted finish. Stainless steel end panels are rustproof. All screws and mounting hardware are stainless steel and rustproof. Bottom panel is aluminum and rustproof. All channels on the amp have crossovers so they can each be used for subs or full range speakers or tweeters or midrange speakers. All channels on the amplifier are bridgeable. Fully Adjustable 12dB / Octave Crossover with Differential Circuitry. Adjustable Subsonic Filter: 15Hz - 40Hz (This filter is on the HPF knob). Adjustable Low Pass Filter: 40Hz - 4kHz. Adjustable Band Pass Filter: 15Hz - 4kHz (use both the HPF and LPF filter).
- Adjustable High Pass (Subsonic) Filter: 15Hz - 4kHz (use both the HPF and LPF filter). Fully Adjustable 12dB Bass Equalizer. 2CH/4CH Input Mode Switch. Status Mode LED Indicator. Adjustable Input Level Control. Mute and Delay Soft Start System. Minimum THD at Rated Power: 90 dB. Frequency Response: 10Hz - 50kHz. Damping Factor: >85 @ 100Hz. (2) 35 Amp ATC Fuses. High-Speed MOSFET Power Supply. Studio-Grade Bipolar Output Stage Transistors. 8 Volt Preamp Circuitry. 35 Amp x2 ATC Fuse. Microphone input and PA microphone included. Product Dimensions (W x H x L): 9" x 2.4" x 15.1" inches. Product Weight: 7.7 Lbs
- Features of RGHR2: Rockville RGHR2 Weather Resistant Gauge-Hole Digital Media Receiver w/Bluetooth/USB/AM/FM. Fits into a standard Gauge-Hole (Tachometer) Opening. Built-in 72 x 4 Watt Peak high powered amplifier (28 x 4 RMS). Built in EQ with preset EQ curves (Pop, Class, Rock, Flat). IP66 Waterproof Certification (Tested to withstand the elements). USB Input to play back audio files store on a USB thumb drive or any other USB device. RCA Aux Input. AM/FM Radio Built In with 18 FM and 12 AM presets + US and European tuning. Bluetooth built in to stream audio from any Bluetooth enabled device. USB Input Charges Your Phone.
- Two Sets of RCA Outputs (Front and a switchable rear/sub) allow you to connect external amplifiers. Big easy to use buttons. Backlit LCD display. Wired Remote Control Included (normally $50). Required Cutout: 2.96" (diameter) x 2.75" (depth). USB is 500mA and 5V and supports 16GB max. Dimensions:. 2.96" cutout mounting diameter. 4.45" diameter top plate. 3.9" mounting depth (not including top plate). 5.0" depth including the top plate. Specs of the built in amplifier:. TDA7851L quadbridge power amplifier. 4 x 72 watts peak @ 2 ohm. 4 x 48 watts peak @ 4 ohms. 4 x 28 watts RMS @ 4 ohms. Highly efficient even when running at 2 ohms!. Low distortion even at top volumes
- Features of MRCA25: Rockville MRCA25 RCA Interconnect Cable. 25' Ultra-Flexible PVC Shield. Twisted Pair. Premium Audiophile Marine RCA Interconnect Cable. High Performance Water Proof RCA Plugs. Tinned Copper Strands for Sonic Purity. Outstanding Noise Rejection, Accuracy, and Frequency Response.
- Features of RMWK4 V2: Rockville RMWK4 4 AWG Gauge Waterproof Marine/Boat Amplifier Wire Installation Kit. 20' Translucent, Twisted Pair, High Quality, Tinned-OFC Flexible PVC RCA Cable. 18' 4 Gauge High Current, Low Impedance, Clear Flexible Power Cable with 3' Black Poly Woven Mesh to better resist chemicals in the battery compartment. 18' 4 Gauge High Current, Low Impedance, Light Blue, Flexible Ground Cable. 25' 16 Gauge 100% Tinned-CCA, White, Non-Transparent Resin PVC, Flat Speaker Cable. 25' Blue Remote Wire. (1) Silver Mini-ANL Fuse Holder - Clear Shell and Clear Blue Bottom Bracket with Blue Waterproof Ring. (1) 120A Mini-ANL Fuse. (1) 80A Mini-ANL Fuse. (2) Ring Terminals.